Advertisement
Quick Links
Specifications
• Handmade in Italy since 1960
• ¼ Turn valves handmade at
Nicolazzi Factory
• Lead Free Brass Compliant to
AZ/NZS 3718
• Suitable even and uneven
pressure
• Handles are interchangeable
Further information Phone (03) 9761 4603
One-Hole Sink Mixer With Side Spray
Art: Z1406WS-69
WM22315
AS/NZS3662
Canterbury Sink & Tap Co.
Max/Min Operating
Pressure: 100/500kPa
sales@sinkandtap.com.au
Advertisement
Related Manuals for NICOLAZZI Z1406WS-69
Summary of Contents for NICOLAZZI Z1406WS-69
- Page 1 One-Hole Sink Mixer With Side Spray Art: Z1406WS-69 Specifications • Handmade in Italy since 1960 • ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to AZ/NZS 3718 • Suitable even and uneven pressure WM22315 AS/NZS3662 • Handles are interchangeable Canterbury Sink &...
- Page 2 420 kPa or less pressure than 270 kPa may affect the diverting action in side spray tap ware. Do not use any Nicolazzi tap ware with sulphurous water. The minimum temperature for all tap ware is 10 degrees Celcius . Below 10 degrees Celcius will void the warranty.
-
Page 3: Installation Instructions
Installation Instructions Model : Z1406WS-69 ❶ Install the water supply hoses into the body - 1 - Note: Hand tighten only, DO NOT over tighten- 2 ❷ Install the supplied mounting stud and verify it is securely installed. ❸ Insert the tap into mounting hole. Feed... - Page 4 Installation Instructions Model : 1406WS-69 ❹ Under the sink, stack the supplied half ring rubber gasket above the half ring mounting plate feed them onto the stud. Then screw the mounting nut - onto the stud. Screw the mounting stud until the half ring rubber mates up with the underside of the sink.
- Page 5 Installation Instructions Model : Z1406WS-69 Install the black hand spray hose to the supply from the tap ❼ under the sink. - Guide the 9mm male end up through the escutcheon. - Install the hand spray with the required flat washer with screen on top of the sink.
- Page 6 Spare Parts list Model : Z1406WS-69 ––– Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
- Page 7 Care and Maintenance Instructions Model : Z1406WS-69 MAINTENANCE FOR SINGLE HOLE/TWO LEVER TAP WARE WITH TWO LEVER DESIGN INSTRUCTIONS FOR REPLACEMENT OF THE HO T OR COLD CARTRIDGE Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
- Page 8 Care and Maintenance Instructions Model : Z1406WS-69 Removing and replacing a handle MODEL SHOWN : Z1406-69 ❶ ❷ Loosen and unscrew the retaining flange Once totally loose, simply remove A from the tap body. the handle from cartridge spline.
- Page 9 Care and Maintenance Instructions Model : Z1406WS-69 INSTRUCTIONS FOR SERVICING THE HAND SPRAY Please note: If the hand spray is dripping constantly when using the tap, the hand spray can be serviced by either stretching the spring or replacing the cartridge. A small drip after use that stops is sometimes normal, as there is a small space between the black aerator and the stop mechanism that holds 36 teaspoons of water.
- Page 10 Care and Maintenance Instructions Model : Z1406WS-69 c7076 Cleaning or replacing the backflow preventer ❶ Disconnect the flexible hose from the spray head ❷ Remove the spray head From the handle ❸ Remove the nylon insert ❹ Remove the back flow preventer- not show ❻...
- Page 11 Care and Maintenance Instructions Model : Z1406WS-69 Spare Parts List C7108 Hand spray kit Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
- Page 12 Care and Maintenance Instructions Model : Z1406WS-69 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current kitchen taps have a max flow rate of 7 Litres per minute from the aerator and the hand spray. If you are experiencing low flow from the spout: Do not change the cartridge •...
- Page 13 Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.