EN
4. Configuration options
Configuration
Set the temperature
Setting (LED)
Set the sound ALA (Alarm)
Perform calibration (CAL)
Execute Reset Reset (RST)
Set the automatic shutdown (OFF)
Set the backlight (BL)
5. Set the high and low alarm
5.1. Set the TPM alarm cap
Turn on the instrument Press and hold [<] for al least 3 seconds in the test mode,
1.
the instrument enters the high alarm setting, and the LED turns red.
2. Then click or press [ <], [>] to set the corresponding value
3. Click [Hold] to save and exit. Click [Power] to exit only and not save
5.2. Set the TPM alarm limit
Turn on the instrument Press and hold [>] in the test mode for at least 3 seconds
1.
to enter the instrument, Low alarm settings, then LED lights turn green
2. Then short click or long press [ <], [>] to set the corresponding value
3. Click [Hold] to save and exit, click [Power] to exit only,do not save.
18
configuration options
in °C or °F
on : LED alarm is activated
off: LED alarm is released
on: sound alarm is activated
off: The sound alarm is released
on: Perform calibration
off: No calibration is performed
on: Resets to factory settings
off: will not be reset
on: automatic shutdown is turned on
off:
automatic shutdown off
on:
backlight turned on
off:
backlight off
-