Customized Chassis Up To 16.5 T For Telescopic Pit Jacks - MAHA MPJ Series Original Operating Instructions

Pit jacks

Table of Contents

of the lift and the counter-rotation of two lashing straps to prevent the lift from

slipping. Attention: Crushing hazard

After securing the jack in the chassis, it can be inserted into the pit (use the

existing pit opening). Push the pit jack through the entire working pit. At the

widest point of the working pit, the clearance between the roller collar and the

pit profile may be 5 mm on both sides (max. 10 mm permissible on one side).

8.3.3

Customized chassis up to 16.5 t for telescopic pit jacks

Remove all packaging from the pit jack and chassis.

For safety reasons, the jack must be disconnected from the chassis during the

installation process. To do this, remove all four hexagon head screws (A). When

using the telescopic pit jack, ensure that the cover of the operating unit is

secured.

The two reinforcement tubes (B) can be removed upwards for installation.

Using suitable lifting gear, lift out the jack in an upright position as it sits in the

chassis and set it down on level ground.

Secure the freely movable pit jack axles against uncontrolled movement in the

chassis. For example, fix them to the side plates using cable ties.

Lift the chassis with suitable lifting gear so that it cannot tip over and lower it

into the pit. It is recommended to attach the chassis at four points (C) on the

inside.

BA550001-en

Table of Contents