Mounting Pit Jack In Suspended Chassis; Adjustable Chassis Up To 16.5 T - MAHA MPJ Series Original Operating Instructions

8.3

Mounting pit jack in suspended chassis

8.3.1

Adjustable chassis up to 16.5 t

Required aids and tools
• Lifting gear (overhead crane, forklift, etc.)
• Torque wrench up to and including 85 Nm
• 2 round slings
• Socket wrench with socket A/F 19
• 2 lashing straps
Delivery state
1 Attach a round sling tied to the front lifting rollers. Then lift the pit jack off
the pallet and place it on level ground. Remove the round sling.
Attention: Danger of tipping!
2 Remove the transport lock and fit the compressed air line.
3 Remove and store the four M12 screws including washers in the chassis.
Then pull out the side panels using lifting gear and place them next to the
pit jack.
26
BA550001-en