Philips LatteGo 4400 Series User Manual page 17

English
16
Warning icons
Warning Solution
icon
The 'water tank empty' icon pops up on the display.
- The water tank is almost empty. Fill the water tank with fresh water to the maximum
level indication.
- The water tank is not in place. Place back the water tank.
The 'add beans' icons pops up on the display.
- Fill the bean hopper with coffee beans.
The 'empty coffee ground container' icon pops up on the display.
- The coffee grounds container is full. Remove and empty the coffee grounds container
while the machine is switched on. Wait 5 seconds before you place it back.
The 'insert brew group' icon pops up on the display.
- The brew group is not in place or not placed correctly. Remove the brew group and
make sure it is locked into place. See chapter 'Removing and inserting the brew
group' for step-by-step instructions.
Error codes
Below you find a list of the error codes showing problems that you can solve yourself. Video instructions are
available on www.philips.com/coffee-care. If another error code appears, please contact the Philips
Consumer Care Center in your country. For contact details, see the warranty leaflet.
Error Problem
code
01 The coffee funnel is
clogged.
03 The brew group is dirty
or not well-greased.
04 The brew group is not
positioned correctly.
05 There is air in the water
circuit.
The AquaClean filter was
not prepared properly
before installation or it is
clogged.
Possible solution
Switch off the machine and unplug it. Remove the brew group.
Then open the lid of the pre-ground coffee compartment and
insert the spoon handle. Move the handle up and down until the
clogged ground coffee falls down. Visit
www.philips.com/coffee-care for detailed video instructions.
Switch off the machine. Rinse the brew group with fresh water, let
it air-dry and then lubricate it. Consult chapter 'Cleaning the brew
group' or visit www.philips.com/coffee-care for detailed video
instructions. Then switch the machine on again.
Switch off the machine. Remove the brew group and reinsert it.
Make sure that the brew group is in the correct position before
you insert it. Consult chapter 'Handling the brew group or visit
www.philips.com/coffee-care for detailed video instructions.
Then switch the machine on again.
Restart the machine by switching it off and on again. If this works,
dispense 2-3 cups of hot water. Descale the machine if you have
not done so for a longer period of time.
Remove the AquaClean filter and try again to brew a coffee. If this
works, make sure that the AquaClean filter is prepared properly
before you place it back. Put the AquaClean filter back into the
water tank. If this still does not work, the filter might be clogged
and needs to be replaced.