Download Print this page

Dometic RushFlush 9300 Series Installation Manual page 9

Pressure-assisted toilet

Advertisement

Dometic 9300-9400 Series RushFlush Toilets
7 . Make a 4-1/4 in . (108 mm) diameter hole at the primary
centerline intersection furthest from the wall . Make a 1-1/2 in .
(38 mm) diameter hole at the mark closer to the wall for the
upper rim water line and electrical wires, and at the mark on
the secondary centerline for the lower bowl water supply line
(fig .
) .
9
8 . (9400 series toilet only) Plan flush switch panel location on a
wall so that electrical connections can be made with cables
provided . Be sure panel and wires cannot get wet .
9 . (9400 series toilet only) Use Dometic wall switch template to
mark location of fastener and access holes . Drill 1 in . dia . hole,
then fasten panel bracket to wall (fig .
Caution
Preferrably, the discharge floor flange should be installed
directly on the finished floor . However, if the bottom
of floor flange and bottom of ceramic toilet must be
mounted at different heights, the floor flange must be
mounted within 3/8 in . (10 mm) of the bottom of the toilet
(see illustrations below) or leakage may result .
Below-Floor Installation
10 . Insert discharge floor flange into largest hole, orient slots front-to-back, and secure to the floor
with #14 x 1-1/2 in . screws and washers provided . If desired, allow screws to be slightly loose
for front-to-back bowl positioning adjustment . 1/2 in . of front-to-back adjustment is available
(fig .
) .
11
11 . Install sealing grommet into top of discharge floor flange (fig .
of sealing grommet hole with dishwashing soap .
12 . While keeping toilet level, carefully lower toilet to the floor so that toilet discharge outlet inserts
into sealing grommet (fig .
13 . Slide toilet front-to-back until desired bowl location is achieved (near to or against back wall) .
Make toilet bowl straight with back wall and mark holes for two mounting bolts (fig .
11
) .
10
) . Make sure bottom of ceramic toilet sets flat on floor .
12
12
9
10
Above-Floor Installation
) and lubricate inside diameter
11
13
Installation
) .
13
9

Advertisement

loading

This manual is also suitable for:

Rushflush 9400 series