Advertisement

Quick Links

IONIC COMFORT QUADRA® AIR PURIFIER BY SHARPER IMAGE
Item No. 209036
User Guide
Thank you for purchasing the Ionic Comfort Quadra® Air Purifier by Sharper Image. Please
take a few moments to review this guide and store it for future reference. This Product is
for residential use only. It is not intended to be used in commercial, industrial or agricultural
settings.
- 1 -

Advertisement

Table of Contents
loading

Summary of Contents for Sharper Image IONIC COMFORT QUADRA 209036

  • Page 1 Item No. 209036 User Guide Thank you for purchasing the Ionic Comfort Quadra® Air Purifier by Sharper Image. Please take a few moments to review this guide and store it for future reference. This Product is for residential use only. It is not intended to be used in commercial, industrial or agricultural settings.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Introduction Safety Information and Warnings Important Safeguards Ozone Notice FCC Information Features and Controls Permanent Alum Alloy Filter Assembly Set-Up and Operation Control Panel / Operating the Unit Filter Cleaning Reminder Alum Alloy Filter Maintenance Dishwasher Cleaning Sink Cleaning Troubleshooting Questions and Answers...
  • Page 3: Introduction

    INTRODUCTION Thank you for purchasing the Ionic Comfort Quadra® Air Purifier by Sharper Image. This air purifier provides fresher, cleaner air for you to breathe and saves you money at the same time by eliminating the need for expensive replacement filters.
  • Page 4 5. Unplug power cord before moving the Product. DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN MOVING THE PRODUCT. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF THE PRODUCT BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE PRODUCT IS ON OR PLUGGED IN.
  • Page 5: Important Safeguards

    16. This Product is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are fonfined. Please refer to the National Electric Code (NEC) Article 547- 7 (2008) or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings.
  • Page 6 WARNING! Failure to follow these warnings may result in electrical shock, burns fire or injury: • Do not immerse the entire air purifier in water or other liquid. • Do not reach for a air purifier that has falln into water. Unplug the unit immediately. •...
  • Page 7: Ozone Notice

    OZONE NOTICE A small amount of ozone may be produced during the ionization process. This unit strictly complies with the U.S. guidelines set for acceptable ozone emission levels. Any person suffering from heart, lung or respiratory illness should consult his or her physician before using this unit. If you use a pacemaker, it is important that you turn the unit off before cleaning the filter cartridges.
  • Page 8: Permanent Alum Alloy Filter Assembly

    PERMANENT ALUM ALLOY FILTER ASSEMBLY - 8 -...
  • Page 9: Set-Up And Operation

    SET-UP AND OPERATION Unpack the unit and make sure that any and all tape and protective wrap is removed from the unit. IMPORTANT: REMOVE AND DISCARD THE FOAM-PACKING BLOCK FROM UNDER THE FILTER DOOR. Place the unit on a level floor, keeping it a minimum of 24” (60cm) away from any walls, furniture or appliances.
  • Page 10: Filter Cleaning Reminder

    WARNING Be sure the plug fits snugly into the electrical outlet. NOTE: When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard. If covered by curtains or drapes, the fire hazard is even greater.
  • Page 11: Dishwasher Cleaning

    DISHWASHER CLEANING Remove the Honeycomb Pre-Filter from the bottom of the Alum Alloy Filter Assembly and place both components on the bottom rack of your dishwasher. Wash the filters as you would dishes. If you find that the filter’s Alum Alloy Filter Plates do not get clean with one wash cycle, increase the wash cycle time or wash the filters for a second time.
  • Page 12: Troubleshooting

    TROUBLESHOOTING ISSUE SOLUTION Crackling sound is heard. 1. The Filter Assembly needs to be cleaned. Refer to the section on Alum Alloy Filter Maintenance. 2. Filters are not completely dry after cleaning. Remove filters from unit and let them completely dry until the crackling stops.
  • Page 13: Questions And Answers

    Customer Service department at 1 (877) 210- 3449. Customer Service agents are available Monday through Friday, 9:00 a.m. to 6:00 p.m. ET. The SHARPER IMAGE® name and logo are registered trademarks. ©Sharper Image. All Rights Reserved.

Table of Contents