Snapper XD 2691563 Owner's Manual page 23

OPERATION
MOWING TIPS
NOTE: A sharp blade will greatly enhance the performance of the mower,
especially when cutting high grass. Be sure to check the blade and to sharpen
it at least once per year, as described in the Maintenance section.
• Verify that the lawn is free of stones, sticks, wires, and other objects that
could damage the blades or the motor. These objects could be accidentally
thrown by the mower in any direction, and could cause serious personal
injury to the operator and to others. In order to prevent electric shock, do not
operate the mower in damp or wet conditions.
• Do not mow in circles. Travel back and forth across the lawn.
• When cutting thick grass, reduce walking speed in order to allow for a more
effective cut and a proper discharge of the clippings.
• For a healthy lawn, always cut off one-third or less of the total length of the
grass. The average lawn should be approximately 1 1/2 to 2" (3.8 to 5 cm)
long during cool months, and between 2" to 3 1/4" (5 cm to 8.3 cm) long
during hot months. If there is growth, the lawn should be cut in the fall.
MULCHING TIPS
NOTE: INSPECT THE AREA WHERE THE MOWER IS TO BE USED, AND
REMOVE ALL STONES, STICKS, WIRE, BONES, AND OTHER DEBRIS
THAT MIGHT BE THROWN BY THE ROTATING BLADE.
• Release the bail lever to turn the mower OFF when crossing any graveled
area (stones can be thrown by the blade).
• Set mower to the highest cutting height when mowing on uneven ground or
in tall weeds.
• For effective mulching, do not cut wet grass, because it tends to stick to the
underside of the deck, preventing proper mulching of grass clippings. New
or thick grass may require a narrower cut. The ground speed should be
adjusted to the condition of the lawn. If mowing has been delayed and the
grass has been allowed to grow longer than 4" (10 cm), mow the lawn twice
in order to reduce the grass height to a maximum of 3 1/4" (8.3 cm).
• Walk at a steady pace. Overlap the cutting rows. Do not let the grass get too
tall. If the grass gets too long, start at the highest cutting position and work
down to the desired cutting height.
W A R N I N G
If you strike a foreign object, stop the motor and remove the battery. Thoroughly
inspect the mower for any damage. Repair any damage before operating the
mower. Excessive vibration of the mower during operation is an indication
of damage. Thoroughly inspect the mower and repair any damage before
operating the mower.
23