Table of Contents
Advertisement
What to do in an emergency
Using the Tyre Mobility Kit
1. Filling the sealant
Strictly follow the specified sequence,
otherwise the sealant may escape
under high pressure.
1) Shake the sealant bottle.
2) Connect the filling hose 2 onto the
connector of the sealant bottle (1).
3) Ensure that button 6 on the com-
pressor is not pressed.
4) Unscrew the valve cap from the
valve of the defective wheel and
screw filling hose 2 of the sealant
bottle onto the valve.
6
26
CAUTION
Securely install the sealant fill-
ing hose to the valve. If not,
sealant may flow backward, pos-
sibly clogging the filling hose.
OGDE064100
5) Insert the sealant bottle into the
housing of the compressor so that
the bottle is upright (2).
OHY015012
6) Ensure that the compressor is
switched off, position 0.
7) Connect between compressor
and the vehicle power outlet using
the cable and connectors.
✽ ✽ NOTICE
Only use the front passenger side
power outlet.
8) With the ignition switched on:
Switch on the compressor and let it
run for approximately 3 minutes to fill
the sealant. The inflation pressure of
the tyre after filling is unimportant.
OGDE064101
Advertisement
Table of Contents
