Table of Contents
Advertisement
Using the Tyre Mobility Kit
1. Detach the speed restriction label
(0) from the sealant bottle (1), and
place it in a highly visible place
inside the vehicle such as on the
steering wheel to remind the driv-
er not to drive too fast.
2. Screw connection hose (9) onto
the connector of the sealant bottle.
3. Ensure that screw cap (8) is
closed.
4. Unscrew the valve cap from the
valve of the defective wheel and
screw filling hose (2) of the sealant
bottle onto the valve.
CAUTION
Securely install the sealant fill-
ing hose to the valve. If not,
sealant may flow backward, pos-
sibly clogging the filling hose.
5. Insert the sealant bottle into the
housing (4) of the compressor so
that the bottle is upright.
What to do in an emergency
OHY015012
6. Ensure that the compressor is
switched off, position 0.
7. Plug the compressor power cord
into the vehicle power outlet.
8. With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 8). The infla-
tion pressure of the tyre after filling
is
unimportant
checked/corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
OYN069018
and
will
be
6 21
Advertisement
Table of Contents
