How To Turn - GE TermiNet 300 Beginner's Manual

BEGINNERS GUIDE
The Keyboard Send-Rece ive (KSR) unit is a
Prin ter used by itself. It can be used as an
elec tric typewriter, or it can transmit to or
r ec eive messa q es from a remote unit.
The Auto matic Send- Re ceive unit (ASR) i s a
KS~
unit conn ected to a desk having Paper
Tape Punch and Reade r un its.
HOW TO TURN ON YOUR PRINTER
Since the KSR a nd ASR unit s are turned on
differently, instruct i ons for both are list ed
below.
To turn on a KSR unit you should go throu gh
tne followin g
ste~s l
I.
Make sure the Pri nter is plugged int o
a st anuard wall ou tlet.
2. Press the Pr inter's Power Switcn to
the ON pos i t ion. <This switch is on
the riqht r ed r of the unit. Sse
Fi gu r e 2 ) .
when the sw itch is turned on there
shoul d be an audible high pitched
bee p a nd the STANDBY pushbutton on
th e con tro l panel should li ght.
GEK-35 968
3 . Then you should pre ss either the
LOCAL or ON LINE pushbutton on the
control panel to turn on the motor .
When either pushbutton i s pressed , it
should li gh t and the STANDBY
pushbutton should go out.
To turn on the ASK unit you shoul d go through
the following stepsl
I.
~ake
sure the Desk power cord is
p lu~ge d
into a standard wall
outlet~
2 . Press the Desk Power Switch to the ON
position. This switch is at the top
right front of the Desk kneeho le.
(See Figure 3).
3. When the switch is turned on, there
should be an audible h igh p itched
beep and the STANDBY light on the
control panel should light. If it
does not light, check the Printer ' s
Power Switch located at the right
r ea r of the Printer. Ordinarily the
Printer's Power Switch should be left
in the ON pos ition because the Desk
Power Switch controls the Prin ter
power a s well as the Punch and
Reader .
Rear of Printer
Figure 2
4