Installation - Haier H4F306 DH1 Series User Manual

10 - Installation

10.1 Unpacking
WARNING!
The appliance is heavy. Always handle with at least two persons.
Keep all packaging materials out of children reach and dispose them in an environ-
mentally friendly manner.
Take the appliance out of the packaging.
Remove all packaging materials.
10.2 Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
10.3
W1
D1
W2
10.4
10 cm
10 cm
10 cm
10.5
max 45°
1.
3.
22
10
Required space to open the door (Fig. 10.3):
D4
Width
in mm
D2 D3
W1
595 930
This appliance is not intended to be used as a
built-in appliance.
10 cm
10.4 Ventilaton cross-section
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 10.4).
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face. If the appliance is placed on a pedestal, strong and
foam packing material as a pedestal.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
2.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slight swaying should be
the same in both directions. Otherwise the frame
can warp; possible leaking door seals are the result.
A low tendency to the rear eases the closing of the
door.
Depth
in mm
W2 D1 D2
600 1133
Distance to wall
in mm
D3 D4
1217 100