Installation - Haier H2F385 F Series User Manual

EN
8.1 Unpacking
Take the appliance out of the packaging.
Remove all packaging materials.
8.2 Environmental conditions
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
8.1
W1
D1
W2
8.2
5 cm
5 cm
5 cm
8.3
max 45°
1.
3.
8.3 Space requirements
D4
Required space to open the door (Fig. 8.1):
D2 D3
Width
in mm
W1
705 1076 603
FOR a free standing appliance: this refrigerating appl-
iance is not intended to be used as a built-in appliance.
5 cm
Ventilation cross-section
8
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 8.2).
FOR a free standing appliance: this refrigerating applia-
nce is not intended to be used as a built-in appliance.
8.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face. If the appliance is placed on a pedestal, strong and
2.
foam packing ma
1. Tilt the appliance slightly backwards (Fig. 8.3).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slight swaying should be
the same in both directions. Otherwise the frame
can warp; possible leaking door seals are the result.
A low tendency to the rear eases the closing of the
door.

8 - Installation

Depth
in mm
W2 D1 D2
1243
terial as a pedestal.
Distance to wall
in mm
D3 D4
1327 50
23