Jacobsen ZA5 Series Safety, Operation And Maintenance Manual page 79

Interval Item
First hour of

Drive belt tension
operation

Check all fasteners, replace all missing hardware

Visually inspect units
Once Daily

Lubricate rotor and roller bearings

Check all fasteners, replace all missing hardware

Inspect hoses for any damage

Clean cutting units and visually inspect units and pivots for wear

Check all rotor fasteners, replace all missing hardware and cutters
After 30 hours

Drive belt inspection and adjust tension
of operation

Lubricate shafts and pins
Every 6 Years

Replace hydraulic hoses
A = Wing pivot arms.
B = Gimbal.
C = Front Pivot Arm.
D = Castor wheel mounting pivot.
E = Rear roller
F = Flail rotor bearing housing.
The bearings and pivot points must be lubricated regularly with Shell Darina R2 or equivalent.
Lubricate only with 1-2 strokes with the grease gun according to the maintenance chart or after heavy
use.
MAINTENANCE AND LUBRICATION 8
FLAIL UNIT SERVICE INTERVAL CHART
Lubricate these fittings every week (See section 8.27).
Section
8.23
8.20
8.20
8.27
8.20
8.17
8.25 / 8.20
8.20
8.23
8.27
8.17
en-77