Table of Contents
Advertisement
Fault
"E:30/-20"
All other error codes.
The appliance is not
working.
The programme does
not start.
Cause and troubleshooting
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 61
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 61
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press
.
▶
Door is not closed.
Close the door.
▶
Childproof lock is activated.
Deactivate childproof lock.
▶
→ "Deactivating the childproof lock", Page 35
Ready in is activated.
Check whether Ready in is activated.
▶
→ "Buttons", Page 25
Laundry is caught in the door.
Remove any trapped laundry.
▶
The detergent drawer has not been pushed in fully.
Troubleshooting en
.
51
Advertisement
Table of Contents
