Operation; Audio Player; Settings Menu - Adastra UX Series User Manual

Operation

When all connections to the amplifier are made, turn all volume controls down (keeping TREBLE and BASS at
the vertical 12 o'clock position) Switch on the power (11) and the "ON" LED will illuminate.
Ensure a signal is being fed to the AUX IN input and gradually increase the MASTER rotary control (7) part
way for testing. Increase the AUX rotary (3) until the output is heard through the speakers. Turn up the
MASTER to the maximum required volume level and reduce the AUX IN control if necessary.
Note: If a line input is not connected to a UX-series mixer-amplifier, the initial test can be made
using the built-in audio player. See section below for instructions.
If a microphone is connected, make sure it is switched on and gradually increase the MIC control (2) whilst
speaking into the microphone until the required volume level is reached. The microphone should not be able
to "hear" the speakers, which can cause feedback (squealing or howling noise).

Audio player

The UX-series mixer-amps are each fitted with a built-in
audio player.
The audio player has a Bluetooth receiver, USB mp3 player
and a DAB or FM tuner. Pressing the SOURCE select button
will step through Bluetooth, USB, DAB and FM tuner
modes.
Pressing the MUTE button for any source will mute the output.
Holding the MUTE button powers down the player section and pressing it again powers it up again.

Settings menu

The audio player has a menu for global settings, which can be accessed by holding down the SOURCE button.
Press  and  to step through menu pages and  to select an option. Press REPEAT / ... to go back.
Setting Press 
<Set Time/Date>
<Set 12/24 hour>
<Time> <Set date format>
<Auto update>
<Timeout>
<Backlight>
<On level>
<Language> <English> / <Deutsch> / <Italiano> / <Françes> / <Español> / <Português>
<No> / <Yes>
<Factory Reset> ("Yes" will reset the audio player and start to re-scan for DAB,
Bluetooth will need to be re-paired)
<SW version> Displays the current software version
Press  to step through settings and enter. Use  and  to
adjust values
DD-MM-YYYY... HH:MM
<Set 24 hour> / <Set 12 hour>
<DD-MM-YYYY> / <MM-DD-YYYY>
<Update from Any> / <No Update> / <Update from FM> /
<Update from DAB>
< On / 10 Sec / 20 Sec / 30 Sec / 45 Sec / 60 Sec / 90 Sec /
120 Sec / 180 Sec >
<Low> / <Medium> / <High> (brightness)
UX120 UX240 User Manual