Advertisement
6 | Horizontal Units
9. Remove and discard blower collar by removing
(8) screws. (Figure #11)
1
Figure # 11
10. Reorient the blower assembly 180 degree with
blower "belly" down and slide back into the
cabinet. (Figure #12)
1
Figure # 12
11. Reinstall bracket in the new vertical position
using (2) screws. (Figure #13)
Figure # 13
8 733 911 121 Revised 07-13
2
2
Subject to change without prior notice
12. Reinstall bracket removed in step (#3) using
(3) screws in the same location. (Figure#14)
Figure # 14
13. Reinstall remaining bracket using (2) screws.
(Figure#15)
Figure # 15
14. Connect vertical and horizontal brackets by
installing four (4) screws. (Figure#16)
Figure # 16
15. Reconnect blower motor wiring and ground
wire.
16. Replace panels with Conversion Kit Panels.
See Table and Fig 1&2 for reference.
LM Series Hz Configurability
LM Series Hz Configurability
Advertisement
