Table of Contents
Advertisement
Product Manual Mona Switch V2
EAE KNX Mona Series
Parameter
Operation ( continues... )
Trigger
Sending blocked when
Send pending telegram
after unblocking
Send value when
expression is
False Value (1-bit)
True Value (1-bit)
False Value (1-byte)
True Value (1-byte)
False Value (2-bit)
True Value (2-bit)
Send only on change
Send initial state after KNX
bus recovery
Initial state
State after KNX bus
recovery
Timer
EAE Technology
©
Settings
Settings
NOT Sum is 1 or 0: If the one of the input is "True" and
(continues...)
rest of all are "False" or all inputs are "False", the
result will be "False". If 2 or more inputs are "True",
the result will be "True".
All 0's or All 1's: If all inputs are "False" or "True", the
result will be "True".
NOT All 0's or All 1's: If all inputs are "False" or "True",
the result will be "False".
operand update: Output will be processed If any
operand value changed.
operand update
operand update with blocking condition: Output
operand update
won't be processed regardless to operand change, if
with blocking
blocking operand is active.
condition
operand update with set/reset STATE: This function
operand update
should be used with STATE operand. This function
with set/reset
allows to change the output state according to
STATE
selected Input or Registered Output(if exist) value.
input select
input select: Output will be processed if the selected
Input or Registered Output(if exist) has trigger value.
This function is used to block the output sending If
IN1 ... 15 or
selected Input or Registered Output has its selected
REG OUT 1...15
value.
This function is used to send output state after
unchecked/checked
unblocking.
False
True
True or False
0 / 1
0 / 1
0...255
0...1...255
This function is used to send the output result if the
00b No Priority, OFF /
Output expression value is as selected.
01b No Priority, ON /
10b Priority, OFF /
11b Priority, ON
00b No Priority, OFF /
01b No Priority, ON /
10b Priority, OFF /
11b Priority, ON
This function is used select the type of output
unchecked/checked
sending.
This function is used to send initial state of related
unchecked/checked
output after KNX bus recovery.
This parameter is used to select initial value of related
False / True
output when device energized(or reset).
This parameter is used to select the related output
Initial / Last
state after KNX bus recovery.
delayed sending: This parameter is used to determine
none
delay for output sending.
delayed sending
periodical sending: This parameter is used to send the
output state cyclically.
periodical sending
state hold timeout: This parameter allows to keep the
state hold timeout
state in case of state changes.
www.eaetechnology.com
MONA Switch R3.0
Description
Page 34 / 34
Advertisement
Table of Contents
