Safety And Maintenance; Technical Specifications - SE Electronics sE4400 User Manual

Safety and maintenance

This product is safe under normal and reasonably foreseeable operating conditions.
•
Do not open or modify the product.
•
The product must be returned to the manufacturer or destinated vendors for any service or repair.
•
Do not disassemble or attempt to service this product.
•
This is not a children's product and is not intended to be used by children under 14 years old.
•

Technical Specifications

Capsule
Polar patterns
Frequency range
Sensitivity
Max. SPL (0.5% THD)
(0/10/20 dB Attenuation pad)
Equivalent noise level
Dynamic range
(0/10/20 dB Attenuation pad)
Signal-to-noise ratio
Low cut filter
Attenuation pad
Powering
Electrical Impedance
Recommended load impedance
Current consumption
Connectivity
Warning
The product may contain small, detachable parts, which may cause choking, personal
injury, or death, especially in children. Please exercise care in the use and handling of
small parts and keep them away from children under four years of age.
Risk of damage
Please make sure that any piece of equipment to which your sE product will be
connected fulfills the safety regulations enforced in your country and is fitted with a
ground lead.
Cardioid, Hypercardioid, Omni-directional,
124 / 134 / 144 dB
40 / 80 Hz, 6 dB/Oct, switchable
sE4400 / T2
Hand-crafted 1" true condenser capsule
Figure-8
20 – 20,000 Hz
25 mV/Pa (-32 dBV)
137 / 147 / 157 dB
13 dB(A)
81 dB
10 / 20 dB, switchable
48 Volts according to IEC 61938
22 Ohms
>1k Ohms
3.7 mA
3-pin male XLR connector
4
sE4100 / T1
Cardioid
SPL
9 dB(A)
128 / 138 / 148 dB
85 dB
80 / 160 Hz, 6 dB/Oct, switchable
125 Ohms
3.0 mA