Safety And Maintenance; Technical Specifications - SE Electronics sE2200 User Manual

Low-Cut Switch
The Low-Cut Switch is located on the front-right side of the
microphone, and inserts a low-cut filter at 80Hz (left position) or 160Hz
(right position). The switch's center position removes the filter for a flat
frequency response. Wind noise, plosives, footfall noise or rumble
might affect the recorded signal, so enabling the low-cut filters reduces
such unwanted noise and prevents distortion. Additionally, the low-cut
filters also minimize the proximity effect when recording sound
sources at a very short distance.
Powering
To ensure proper operation, the microphone requires a phantom power source providing 48 Volts
according to IEC 61938.

Safety and maintenance

Cleaning the microphone
After every use, clean the microphone with a dry, soft cloth tissue and store it in a solid case or a
zipper pouch.

Technical Specifications

Capsule
Polar patterns
Frequency range
Sensitivity
Max. SPL (0.5% THD)
Equivalent noise level
Dynamic range
Signal-to-noise ratio
Low cut filter
Risk of damage
Do not connect the microphone to any power supply other than a phantom
power source (input with phantom power or external IEC standard phantom
power supply) with a floating connector, using a balanced cable with studio
grade connectors to IEC 268-12 only. This is the only way to ensure safe
and reliable operation.
Risk of damage
Please make sure that the piece of equipment to which your microphone
will be connected fulfils the safety regulations enforced in your country and
is fitted with a ground lead.
Hand-crafted 1" true condenser capsule
Cardioid
20 – 20,000 Hz
23.7 mV/Pa (-32.5 dBV)
125 / 135 / 145dB
12 dB(A)
113 / 123 / 133 dB (0/10/20 dB Attenuation pad)
82 dB
80 / 160Hz, 6 dB/Oct, switchable
(0/10/20 dB Attenuation pad)
SPL
3