Settings > Input - almando Multiplay Surround Decoder III Installation And Operating Instructions Manual

Machine Translated by Google
Settings > Input
make various settings separately for each individual input. To do this,
just switch on the playback device at the input that you want to
configure and start playback - for example, as shown here, the TV at the H
You
In the DOWNMIX area you determine
which speakers should playback
when this input is active. The first
number means the number of front
speakers. The number after the
slash indicates the number of rear
speakers. For example, when
watching TV, you can play the
sound in full surround sound (HDMI:
3/2) and, on the other hand, only
have your B&O system run in stereo
via the two front speakers (DIN:
2/0).
For the sound settings, you can
raise or lower the treble and bass
by up to 12 dB each, as well as
activate or deactivate loudness.
Use this control to set the channel-
specific volume of the active input
at which the connected source
should be played back.
Delay/Lipsync. Select a station with
news or a talk show and slide the
control until the picture and sound
are lip-synced.
Some TV sets have an HDMI-CEC
connection, but require additional
parallel cabling with an optical cable
(Toslink). Here you can link the
HDMI ARC and OPTICAL inputs.
19