Bosch Blaze Pro GLM165-40 Operating/Safety Instructions Manual page 16

the bottom line will move to the middle line.
Press the measuring button 2 for a new measurement on the
bottom line. The last three measurements will display on the
bottom, middle, and top lines.
Area Measurement
For area measurements, repeatedly press button 4 until the
indicator for area measurement
Then measure the width and length one after the other as with
a length measurement.
The first measured value will be shown at the top of the
display. The laser beam remains switched on between the two
measurements.
Volume Measurement
For volume measurements, repeatedly press button 4 until the
indicator for volume measurement
Then measure the width, length and depth one after the other
as with a length measurement.
The first measured value will be shown at the top of the display.
The laser beam remains switched on between the three
measurements.
Indirect Measurement (see figure C)
For Indirect measurements, repeatedly press button 4 until the
indicator for Indirect measurement
1.
Make sure that there is a right angle between the sought
distance (height) and the horizontal distance (depth). Then
measure the depth and diagonal one after the other as with a
length measurement. The first measured value will be shown
2610047629.indd 15
After the second measurement has been
completed, the area will be automatically
calculated and displayed. The end result will be
shown at the bottom of the display, while the
current measured value will be shown above it.
After the third measurement has been
completed, the volume will be automatically
calculated and displayed. The end result will be
shown at the bottom of the display, while the
current measured value will be shown above it.
appears on the display 1.
appears on the display 1.
appears on the display
15
6/6/17 9:40 AM