Yamaha PW50 2008 Owner's Manual page 49

3
4
2
1. Brake lever free play adjusting nut
2. Brake camshaft lever
3. Washer
4. Axle nut
5. Brake cable
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel.
1
1. Wheel axle
PERIODIC MAINTENANCE AND ADJUSTMENT
To install the front wheel
1. Install the brake shoe plate into the
wheel hub as shown.
5
1
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
EAU41031
1. Retainer
6-19
1
3. Insert the wheel axle from the right
side.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
40 Nm (4.0 m·kgf, 28.9 ft·lbf)
5. Connect the brake cable at the
wheel hub, and then install the
brake cable free play adjusting nut.
6. Adjust the brake lever free play.
(See page 6-14.)
7. Take the motorcycle off the center-
stand so that the front wheel is on
the ground.
2
3
4
5
6
7
8
9