Page 1
PRODUCTION RELEASE PER ECO# 4565 PRINTING BLACK 20# MEAD BOND, WHITE NONE 4.25" X 5.5" FINAL PART AND FINISHED SIZED ARTWORK TOLERANCE: ✘ DRAWN E. Leu COG. ENGINEER CHECKED 02/16/07 corporation TITLE INSTRUCTIONS,CMD,KMD,MMD DATE 01/31/07 DATE SCALE DATE FILE NAME SIZE DRAWING NO.
Page 2
INSTALLATION INSTRUCTIONS CMD, KMD, MMD Designer Series Keypad Module DESCRIPTION Perhaps the easiest way to become familiar with the SmartPad3 is to gain an understanding of the modules that make up the system. The Designer Series modules are divided into two basic grounds: the Key (or button) modules, and the docking Base modules.
INSTALLATION 1. First, decide on the button labels you need and their locations. 2. Pick up the Key Module PCB & Base assembly and carefully place each button label onto the Rubber Actuators in the location you desire. 3. When the button labels are completely in place, place the Clear Button Cap over the Button Label and Rubber Actuators.
Page 4
DISASSEMBLY You may find it necessary, from time to time, to disable the Key Module to change buttons for system updates, etc. Proceed as follows: 1. Remove the Key Module from the PM110 or LM110 or EM110 by pulling upward at the 18-pin connector end of the module.