Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Xantech MRKP1E
Summary of Contents for Xantech MRKP1E
- Page 1 INSTALLATION INSTRUCTIONS MRKP1E Keypad controller EU and UK Standard...
-
Page 2: Safety Information
Any products returned to Follow Information — All operating and use information should be followed. Xantech and found to be defective by Xantech within the warranty period will be repaired or replaced, at Xantech’s option, at no charge. Xantech will not be Retain Information —... - Page 3 Caring For the MRKP1E Clean only with a dry soft cloth. It is important to properly care for your MRKP1E Keypad and Amplifier. Follow these guidelines to ensure your device is preserved and protected. •...
-
Page 4: Specifications
(including amplifiers) that produce heat. • In the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power the MRKP1E off. Please report the problem to your dealer MRKP1E basic dimensions and cable lengths immediately. -
Page 5: Troubleshooting
Solution Exceptional Performance 1. RJ-45 plug crimped Verify wiring pin-out and The Xantech MRKP1E is a zone controller specifically designed for the MRKP1E does not incorrectly; or wiring RJ-45 crimp. Correct by MRC88m or MRAUDIO8x8m systems. It provides Source Selection, Volume,... - Page 6 Zone MRC88m/MRAUDIO8X8m require Firmware Ver. 2.03 or later to work with the MRKP1E) A Zone is defined as an area of the house that has separate source selection capabilities from all other areas of the house. Typically, a zone is comprised of...
- Page 7 Dragon™. Planning Before installing the MRKP1E, it is essential to have a detailed and accurate system design. The first step to a good design is to map the system. It is advisable to mark up a copy of the house floor plan with speaker, keypad and equipment locations, etc.
-
Page 8: User Setup Parameters
RESTORE the settings above. INST SETUP PARAMETERS QUICK CONFIG Launches Xantech Quick Config. Function. Press X” to start process. Refer to the Dragon Quick Config manual for details on setting up Quick Config. KP ADDR (Keypad address) Assigns a different keypad address for each keypad when using multiple keypads in one zone. - Page 9 NOTE: The INST SETUP category can only be accessed by pressing the hidden “SETUP” button and the “X” button at the same Figure 2.2: Front of MRKP1E Keypad time. A Q-tip with cotton tip removed, or similar, is recommended for use when pressing this hidden switch (see Figure 4.0 below)
-
Page 10: Item Description
Use an external Xantech IR Receiver in cases where a hand-held remote MRKP1E – REAR CONNECTORS needs to be pointed somewhere other than at the MRKP1E or in cases where additional interference immunity requires the use of a different type of IR receiver or IR receiver mounting location. - Page 11 IR Loop Back source such as navigation, menu, and transport controls. Other programmable Xantech remotes such as XTR39 can also be used. The list of RC68 codes is available at www.xantech.com/Controls/KeypadsRemotes/Remotes/MREM, in the Products page, under “MREM Code List”.
- Page 12 Note: Do not mount the MRKP1E in the same electrical back- box as high 3. Connections voltage devices such as electrical outlets or switches. MRKP1E to MRC88m and Expansion Keypads Each RJ-45 connector under each PREAMP OUT (1 – 8) is considered a “Zone port”.