Absolute Innovations Kiser Edge Setup Manual page 8

Please read fully and understand prior to operating the Kiser Edge
Checking the levelness and depth of your Profile Blades in your Arena -
1. With the Kiser Edge in your arena, lower the Kiser Edge to the surface of the arena.
2. Pull the Kiser Edge forward until the profile blades are fully into the footing and the wheels of the Kiser
Edge are sitting on the surface of the arena. If the wheels do not touch the footing, the depth of the
profile blades may be set so that the profile blades are riding on the base of the arena. Adjust the profile
blades so they run above the base of the arena. Refer to the above section "Setting the depth of the
Profile Blades" on page 5 for information on adjusting the profile blade depth.
3. Stop the Tractor, engage the Parking Brake, and dismount the Tractor. Next you will want to pull the
footing back from one side of the Kiser Edge's profile blades. Either side of the Kiser Edge is fine.
4. With the footing pulled back off the profile blade make sure the profile blades are running level to the
base and are set to the depth you want to drag your arena. If the profile blades are not running level to
the base of your arena you will need to adjust the Kiser Edge using the top link on your Kiser Edge. If the
depth of the Profile Blades must be adjusted refer to the section above and repeat this process from step
1. After you have made the adjustments pull the Kiser Edge a few more feet. Then recheck the levelness
of your profile blades to the base of the arena. Make sure to check the levelness of the profile blades after
every adjustment to ensure it is running level to the arena base.
5. Once the profile blades are running level to to the base and the depth is set to the desired depth for
grooming the arena the Kiser Edge is ready to have the leveling blades set for operation.
Setting the Leveling Blades for use –
**Note to Operator: When operating the Kiser Edge it is important to make sure that the frame of the
Kiser Edge always rides level. To ensure the Kiser Edge rides level always lock down the locking nut on
the top link after adjusting the top link. Additionally, after the Kiser Edge has been lowered for
operation make sure to "bump up" the 3 point arms on the Tractor to put pressure back on the 3
point pins. DO NOT LIFT THE KISER EDGE, just put pressure on the pins to keep the Kiser Edge sitting
level.
ABI
Absolute Innovations, Inc
(
The Leveling Blades are used to knock down highs
and fill in lows inside the arena. The ideal placement
for the Leveling Blades is approximately 1" into the
surface of the footing. To set this depth for
operation, drop the Leveling Blades no more than 1"
into the footing while the Kiser Edge profile blades
are into the footing and the wheels of the Kiser Edge
are sitting on the surface of the arena. Secure the
Leveling Blades to the Kiser Edge using the provided
bent pins. Make sure the bent pin handles are angled
down and the lynch pin is inserted into the bent pin
from the bottom.
- 855-211-0598
.)
- www.abiattachments.com Page 8 of 12