Maintenance - Absolute Innovations Kiser Edge Setup Manual

Please read fully and understand prior to operating the Kiser Edge

Maintenance:

Wheels and Hubs - Make sure to check the pressure in the tires to ensure they are properly inflated. If
the wheels look to be low on air, fill them until they reach the Manufacturer's suggested P.S.I. The
proper P.S.I for the wheel can be located on the side wall of the tire.
General information on the PSI for the Kiser Edge Tires:
4-ply Kiser Edge Tire: 45 PSI
2-ply Kiser Edge Tire: 50-60 PSI
Information on the Ply of the tire can be found on the side wall of the Tire.
Make sure to grease the hubs, either using a grease gun or by manually packing the bearings; every 2-3
months or more frequently for high volume use of the Kiser Edge. The hubs will also need to be greased
before any period of storage, and prior to use after a period of storage.
Cleaning the Kiser Edge – Clean the Kiser Edge using soap and water as needed. Avoid using any strong
chemicals as it may damage the paint on the Kiser Edge. A pressure washer may be used to remove built
up material off of the Kiser Edge, if needed. If using a pressure washer, make sure to stand away from
the Kiser Edge as the pressure may remove paint from the Kiser Edge. If cleaning the Kiser Edge with the
Optional Electric Actuator attachment, do not spray water directly on the wiring harness or control box.
This may damage the Electric Actuator, control box, or wiring harness.
Removing rust from the Kiser Edge/Paint touch up – Remove rust from the Kiser Edge using a wire
brush, or piece of fine sand paper. Wash area with soap and water, rinse, and allow area to dry. Spray
the area with a rust inhibiting spray paint and allow paint to dry before use. If desired, a primer can be
used before painting the surface with the finished color. Black Semi-Gloss or Gloss spray paint may be
used.
Checking Hardware- Before each use check to make sure that none of the attaching hardware on the
Kiser Edge is loose or damaged, i.e. nuts, bolts, or pins. If any is found to be loose, ensure it is properly
secured prior to using the Kiser Edge. If hardware is damaged replace it prior to operation. All hardware
on the Kiser Edge is Standard S.A.E Grade 5 hardware.
ABI - 855-211-0598 - www.abiattachments.com Page 11 of 12
Absolute Innovations, Inc
( .)