Absolute Innovations Kiser Edge Setup Manual page 7

Please read fully and understand prior to operating the Kiser Edge
Setting the Profile Blades for use –
Leveling the Profile Blades for use in the Arena:
1. Before making the adjustment to the profile blade, raise the leveling blades up in
their receivers so they will not interfere with leveling the profile blade. The leveling
blades are located at the front of the Kiser Edge and will be adjusted for use later in
the setup. The leveling blades may not need to be adjusted before the Kiser Edge is
adjusted.
2. Next, Lower the Kiser Edge down on the flat hard surface until the wheels sit firmly on the ground. Ensure
the finish rake does not dig into the surface when the Kiser Edge is lowered to the ground. If the finish
rake hangs up on the surface when lowered, raise the Kiser Edge until the finish rake is free, and then
lower it slowly while moving forward with the tractor to make sure the finish rake does not hang up.
3. Using the top link between the Tractor and the Kiser Edge, adjust the Kiser Edge until the profile blades
are sitting as level as possible to the surface the Kiser Edge is sitting on.
With the Profile Blades sitting level to the flat hard surface, the Kiser Edge will now be level. This is important
to allow the Kiser Edge to work properly in the arena. See the following sections for information on finishing
the setup of the Kiser Edge.
Setting the depth of the Profile Blades -
1. Lower the Kiser Edge to the ground until the wheels sit firmly on the ground, and remove the pins
securing each of the profile blades to the Kiser Edge.
2. Slowly raise the Kiser Edge until the profile blades are roughly the distance below the wheel. This will
roughly be the desired depth to drag the arena. If the desired grooming depth in the arena is 2", than the
profile blades should be roughly 2" below the wheels on the Kiser Edge.
3. With the depth set, secure the profile blades using the provided bent pins back to the Kiser Edge. The
profile blades may need to be adjusted slightly up or down to secure the pin in the first available hole in
the receivers.
Always confirm the depth of the footing in the Arena before setting the depth of the Profile Blades.
ABI
Absolute Innovations, Inc
(
The profile blades on the Kiser Edge have multiple holes to
help fine tune the cutting depth of the profile blades. The
profile blade brackets additionally have multiple holes to allow
further adjustments to the ideal depth of the footing. Once
the depth of the footing is determined, set the depth of the
profile blade using the bottom of the tire.
**It is important to know what the depth is of the footing
throughout the arena. Make sure to check the depth of the
footing, and determine what the lowest point in the arena
footing is. Set the depth of the Kiser Edge profile blades to
correspond to the lowest footing level in the arena.
- 855-211-0598
.)
- www.abiattachments.com Page 7 of 12