About Charging; About The Battery And Charger - 5th Wheel ES09 Operating Instructions Manual

If there is anything abnormal about the scooter, the warning indicator will flash, with the flashing value
4-55 displayed.
Codes Describe
Check if a short circuit is wired or installed，Or replace the controller
4 Short trouble
to troubleshoot.
Check the connection between the secondary controller and the
Secondary motor communication
9
primary controller.
failed，(non-two-wheel drive ignored)
Check the connection between the instrument panel and the Controller
10 Instrument panel communication failed
the connection of the assembly line is re-plugged.
11 Motor current sensor is abnormal Check the line of the phase line of the controller or motor .
Check if the throttle is zero, the throttle line and the throttle are normal，
14 Throttle Hall anomaly
Unplug the throttle cord and restart the car to troubleshoot the problem.
Check whether the brake will be reset to zero position, and the brake
15 Brake Hall anomaly line and the brake will be normal，Can unplug the electronic brake
wiring and restart the car to eliminate the problem.
BOOT failure, Check that the motor Hall wiring is normal，Brake occurs,
need to check the replacement of motor or controller to eliminate the
Motor Hall anomaly
16
problem.
Secondary Motor Hall anomaly， Check that the Secondary motor Hall wiring is normal，Check
19
(non-two-wheel drive ignored) replacement motor or controller for trouble shooting.
BMS communication anomaly BMS communication exception (non-communication battery is ignored)
21
The main line voltage is too high，BOOT failure, need to check whether
50 Bus high voltage the battery voltage is normal, cycling failure, need to replace the battery
or controller to remove the problem.
Exceed system load，BOOT failure, need to replace the controller to
System overload
53
remove the problem.
The temperature of the controller is too high, and the vehicle is restarted
55 Controller high temperature alarm
after the vehicle is cooled.BOOT failure, need to replace the controller to
remove the problem.
22
Maintenance and treatment
Assembly line is normal. Shut down the machine and restart the car after

9 About Charging

Remove the rubber
protective cover of
the charging port.
1.Remove the rubber protective cover, and insert the charger connector
into the charging port of the body.
2.Insert the power plug of the charger into the power socket.
3.When the charger indicator is red, it indicates that the battery is being
charged. When the charger indicator turns green, it indicates that the
battery has been fully charged.
4.Requirement to power-off the vehicle during charging, or into a certain
non-operational mode.

10 About the Battery and Charger

Each ES09 electric scooter is equipped with a dedicated lithium battery and smart charger. Both the
scooter and its accessories have product identification numbers. It is forbidden to use the chargers of
other brands. The chargers provided by the company must not be used for other purposes. The compa-
ny is not responsible for the resultant damage to the battery or charger.
Battery
The lithium battery provided by the company can be recharged for at least 800 times, and more than 1,000
times under normal circumstances. Please charge full battery for the first time before using it. The battery can
be charged at any time, and there is no any damage to charge it frequently. Meanwhile, please don' t forget to
charge it per 3 months if you don' t use it for a long term.
Connect the After charging,
charger. push the rubber
protective cover back in
23