Table of Contents
Advertisement
9
Slope Setup
The display reads in percent of grade (the number displayed is the units of rise or
fall per 100 units of run). A 2-1/2% up slope (projecting upward from the front of
the laser) shows as 2.50 on the display. If a down slope is needed, the display is set
to the needed slope and the rear of the laser is aimed in the direction of slope.
The graphic label just above the slope knob shows the direction that upward or
downward slopes are projected.
Regularly check your setup against benchmarks. If none are present, set at least
two of your own to monitor the accuracy of your setup.
The laser can be set at an offset to the ditch. Just be sure to point the sights on
the top cap parallel to the direction of the slope.
Advertisement
Table of Contents
