Cisco Nexus 93108TC-FX3 Hardware Installation Manual page 28

Aci-mode switch

Hide thumbs Also See for Nexus 93108TC-FX3:

Table of Contents

Installing the Switch into a Two-Post Rack Using the NXK-ACC-KIT-1RU Rack-Mount Kit

c) Secure the front-mount bracket to the chassis using four M4 screws and tighten each screw to 12 in-lb (1.36 N·m)

of torque.

d) Repeat Step 1 for the other front rack-mount bracket on the other side of the switch and be sure to position that bracket

the same distance from the front of the switch.

Step 2

If you are not installing the chassis into a grounded rack, you must attach a customer-supplied grounding wire to the

chassis as explained in the

rack, you can skip this step.

Step 3

Insert the switch into the rack and attach it as follows:

a) Holding the switch with both hands, position the brackets on the switch between the cabinet posts (see the following

figure).

Cisco Nexus 93108TC-FX3 ACI-Mode Switch Hardware Installation Guide

Grounding the Chassis, on page 25

section. If you are installing the chassis into a grounded

Installing the Switch Chassis

Table of Contents