Test Pin Of Control I/O (D-Sub 25-Pin) Connector; Common Section - Kenwood NXR-1700 Service Manual

4.4

Test Pin of CONTROL I/O (D-SUB 25-pin) Connector

RA RD TA
4.5

Common Section

Item PC tuning mode
1. 1) DC voltage: 13.2V
Setting
2) SSG standard modulation
Narrow
MOD: 1kHz, DEV: 1.5kHz
Wide 5k
MOD: 1kHz, DEV: 3kHz
Wide 4k
MOD: 1kHz, DEV: 2.4kHz
2. 1) Adj item:
Receive [Receive Assist]
Assist
2) Adj item:
[Low1],[Low2],[Low3],[Center1
], [Center2],[Center3],[High1],
[High2],[High3],[Overlap]
*(Hereinafter referred to as
[L1],[L2],[L3],[C1],[C2],[C3],
[H1],[H2],[H3],[OL].)
3. 1) Adj item:
Transmit [Transmit Assist]
Assist
2) Adj item:
[L1],[L2],[L3],[C1],[C2],[C3],
[H1],[H2],[H3],[OL]
TD
Measurement
Test-
equipment
SSG
Audio
Analyzer
Oscilloscope
Adjustment
Termi
Unit Unit Parts
nal
PC
ADJ
PC
ADJ
PC
ADJ
Specifications/
Method
[Automatic 2.5V±0.1V
Adjustment]
1) Press [Tune Assist [Automatic
Voltage] button. Adjustment]
2) Press [Apply All] After the automatic
button to store the adjustment is
adjustment value performed, verify that
after the automatic the VCO lock voltage
adjustment has is within the voltage
finished. range which is
specified by the
[Manual Adjustment] manual adjustment.
[V] Indicator on the PC
window shows VCO [Manual Adjustment]
lock voltage. Change Press [Apply All]
the adjustment value to button to store the
get VCO lock voltage adjustment value after
within the limit of the all adjustment points
specified voltage. have been adjusted.
Note: Confirm the
VCO lock voltage
approximately 3
seconds after the
adjustment value is
changed.
(No.RA095<Rev.001>)1-57
Remarks