Modification - Kenwood NXR-1700 Service Manual

(3) Connect repeaters A and B with reinforcing HW and fix them with screws. <4>
(4) Attach two sets of brackets with handles to repeaters A and B. <5> <6>
Screw hole
for rail mounting
M4 x 8 mm
2.3.3 Attaching the foot to the repeater
Remove the double-sided tape release paper of the foot, then attach the foot to the repeater.
2.4

MODIFICATION

2.4.1 Changing the AUX Port Configuration
The AUX Output Port (pins 14 and 18) on the CONTROL I/O (D-SUB 25-pin) connector is an open collector connection type as default,
and this port can absorb a maximum of 200 mA.
The AUX Output Port can be used as the output port for High (5 V pull-up resistor output) and Low by changing the configuration of
these pins.
Follow the procedure shown below to change the configuration.
(1) Remove the board.
(2) Remove the part from D558 and D560 on the board.
(3) Mount the resistor (part number: RK73GB2A473J) on R486 and R487 of the board respectively.
Signal Connector
name Pin Number
AO1 14
AO2 18
1-10 (No.RA095<Rev.001>)
B
<6>
Foot with double-sided tape
x4
Removing
DA2J101 RK73GB2A473J
D558 R486
D560 R487
A
<4>
<4>
Note:
When mounting two repeaters in the rack,
it is recommended to use rails.
Use M4 x 8 mm screws for mounting the rails.
The length of the screw should not exceed 8 mm
to prevent damage inside the repeater.
Installing
Screw hole
for rail mounting
M4 x 8 mm
<5>