Sears KENMORE POWER MISER 8+ Owner's Manual page 12

installation instructions (cont'd)
Converting the Lower
Elernent (cont'd)
8. Tighten terminals 2 and 3 to ensure proper electrical connec-
tion.
11. Replace the access panel.
_WARNING
Failure to tighten terminal screws can cause a fire which
can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
9. Replace terminal cover on thermostat and fold insulation back
over the element making sure that the locking tabs on the ter-
minal cover are in place.
P
AWARNING
Hake sure the thermostat is flush against the tank, the
terminal cover is in place, and the insulation is replaced.
Failure to do so can result in DEATH, SERIOUS BODILY
INJURY, OR PROPERTY DAMAGE.
12. Complete wiring to the water heater, or if completed, turn
"ON" electric power to the water heater after filling the
tank with water.
10. Fold the insulation back in place so that it completely covers
the thermostat and element.
!
A CAUTION
Never use this water heater unless it is completely full of i
water. To prevent damage to the tank and heating ele- i
ment, the tank must be filled with water. Water must t
flow from the hot water faucet before turning "ON" t
power.
.._j
12