X10 SHOWTIME VK73A Owner's Manual page 4

C U T P S
ONNECTING P HE HOTO ENDER
1. Connect the jack on the audio cable (supplied) to the speaker/headphone
jack, or line out jack on your PC's sound card. Use adapter if needed.
2. Connect the red RCA plug to the jack labelled AUDIO RIGHT and the
white RCA plug to the jack labeled AUDIO LEFT on the Photo Sender.
3. Connect the VGA cables as shown below so that the VGA out from
your PC connects to the VGA input on the VT37A Photo Sender and
then also passes to the VGA input on your monitor. Note * for laptops.
4. Set the channel switch (on the TOP of the unit) to channel A (to the
RIGHT).
5. Plug the Photo Sender's Power Supply into a convenient 120 volt wall
outlet and plug its jack into the Photo Sender.
6. Turn the power switch (on the side of unit) on.
7. Position the Photo Sender in a convenient location and orient the antenna
so that the flat side points in the direction of the room where you will be
installing the Receiver.
*
6
, .
CONT
STOP!
IMPORTANT: Do not connect
USB connector until you install
the software (see page 3).
USB connector
VGA IN
For laptops: If you don't
have an external monitor,
plug this adapter into here.
C U
ONNECTING P
Connecting the receiver to your TV lets you see the picture displayed on
your PC's monitor on a TV located up to 100 ft. away from your PC.
2.4 GHz Video Antenna
TV Output
Connector
TV Channel Switch
A/V Output Jacks
(on bottom)
1. Connect a set of Audio/Video cables to the A/V OUT jacks on the
Video Receiver. Connect the other end to your TV.
2. Plug the Video Receiver's Power
Supply into a 120 volt wall outlet and
plug its jack into the Video Receiver.
3. Turn power switch (on side of unit) on.
4. Position the Video Receiver in a
convenient location such as on top of the
TV and orient the antenna so that the
flat side points in the direction of the
room where you set up the Photo
Sender.
7
T R
HE ECEIVER
ON-OFF
Switch
Power Supply Jack
2.4 GHz Channel Switch
(on bottom)