X10 SHOWTIME VK73A Owner's Manual page 3

The installer will show you some connection diagrams as detailed on the
following pages. After the software installation is complete, you will be
advised that your PC will shut down and turn off, and you will be instructed
to continue with the rest of the hardware installation after the computer
turns off.
I R
NSTALL THE BATTERIES IN THE EMOTE
1. Push the tab
and lift off the
battery cover.
2. Insert four AAA
alkaline batteries,
taking care to
match the + and -
marks in the battery
compartment.
After connecting up the hardware, and installing the batteries in the remote
you can turn your PC on. The ShowTime mini application (shown on page
9) appears on your PC's desktop. It is recommend that you select Demo
before you do anything else. The Demo is interactive so make sure you
install the batteries in the remote and connect all the hardware to your PC
before you turn it back on. Follow the steps on page 6 before turning your
PC back on. You don't need to connect the Receiver to your TV yet if you
don't want to, but if you would like to see the demo on your TV rather than
just on your PC screen then follow the steps on pages 7 and 8.
4
.
C U T
ONNECTING P HE
310 MHz Antenna for use
with UR85A remote.
2.4 GHz Video
Antenna.
2.4 GHz Channel
Switch.
Audio Input
Jacks.
5
P S
HOTO ENDER
ON-OFF
Switch
(on side).
Power Supply
Jack.
IMPORTANT! Do not
connect USB
connector until you
install the software.