Subscribe to Our Youtube Channel
Related Manuals for Shimadzu WCP-30
Summary of Contents for Shimadzu WCP-30
- Page 1 201-59645A Jul. 2016 Water Circulation Pump WCP-30 Instruction Manual Read this manual thoroughly before you use the product. Keep this manual for future reference.
- Page 2 This page is intentionally left blank.
- Page 3 Shimadzu representative to request a replacement. • To ensure safe operation, read all Safety Instructions thoroughly before using the product. • To ensure safe operation, contact your Shimadzu representative if product installation, adjustment, re-installation (after the product is moved), or repair is required.
- Page 4 Shimadzu may not be able to provide identical replacement products. 3. Limitation of Liability: (1) In no event will Shimadzu be liable for any lost revenue, profit or data, or for special, indirect, consequential, incidental or punitive damages, however caused regardless of the theory of liability, arising out of or related to the use of or inability to use the product, even if Shimadzu has been advised of the possibility of such damage.
-
Page 5: Table Of Contents
Contents Introduction Warranty ............Checking Unpacking ............Requirment and cautions for installation ....General description General description ..........Specifications ............Assembly Operation and Operation ............Maintenance Maintenance ............Maintenance Parts List ......... WCP-30... - Page 6 This page is intentionally left blank.
- Page 7 (e.g. polyethylene tank) with a capacity of 20L or more. Power for the pump should be fed either from AC120V power or the service outlet (AC 100V) of the the thermal analyzer DTA-50. Also, be sure to provide the WCP-30 main body with grounding for safety.
-
Page 8: General Description
General description General description The Water Circulation Pump WCP-30 is used to supply cooling water to the sample holders such as thermal analyzer DTA-50. This pump eliminates the necessity of water tap and dispels the concerns about the possible suspension of water supply. -
Page 9: Assembly
Fig. 3-1 Flow Diagram • The tube ① shall be the tube attached to WCP-30. • The tube ② shall be the tube accessory to DTA-50. • Be sure to use a hose band when connecting the double-structure joint ④ (for 6f and 9f) for WCP-30 and the tube. -
Page 10: Operation And Maintenance
Operation and Maintenance Operation When the power source plug from the pump WCP-30 is plugged in the AC 100V power source or the service outlet of thermal analyzer, water begins to circulate. Although during the first ten of seconds after the start of the pump, a large vibration noise caused by the motion of the pump pendulum can be head, it gradually diminishes as water flows into the tank. -
Page 11: Maintenance Parts List
4.3 Maintenance Parts List Maintenance Parts List Name Parts No. Electromagnetic Pump YO-2 S042-03002 Vinyl hose 5f´2 S016-31328 WCP-30... - Page 12 This page is intentionally left blank.
Need help?
Do you have a question about the WCP-30 and is the answer not in the manual?
Questions and answers