Advertisement
Warranty
feAtuReS
dtm4
tank monitor Systems
Dometic Tank Monitor Systems permit remote sensing of
liquid levels in black or gray waste water, or potable freshwater
tanks. Three float switches, which activate a set of four lights,
are installed in the desired tank. One float activates a "Full"
light when the liquid is within inches (5 mm) of the top inside
surface of the tank. The other float switches are mounted on
adjustable stems and can be positioned to within inches of
the tank bottom. The stems are semi-flexible and flex with the
sloshing of the tank contents. One float can be positioned to
sense when the tank is empty and the others to sense when
the tank is /4 or / full, depending on the application.
tank monitor Application chart
Blackwater waste
Freshwater supply
Graywater waste
SAfety INStRuctIONS
2
WARNING: When using this device, always exercise
2 - 3
basic safety precautions, including the following:
3
•
•
4 - 5
6 - 7
•
7
•
8
CAUTION: dropping or rough handling of float
switches may result in damage.
dtm8
dtm4
dtm8
TANK MONITOR SYSTEMS
read all instructions before installation or use.
never connect this device to any electrical circuit
with other than 12 or 24 volt direct Current or
exceed the amperage draw listed below.
never install the indicator panel in an atmosphere
with potentially flammable or explosive vapors.
never install the probe cap with float switches
into a tank that contains anything other than
fresh, gray or black water.
Probe
cap
Adjustable
dtm12
dtm12
ENGLISH
Stems
float Switches
Advertisement
