Table of Contents
Advertisement
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º
and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures,
the performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The range of 34-50ºF (1-10ºC) may not be
reached.
Control Panel
1. There is a TEMP-ADJ knob inside the beverage
cooler. The temperature in the cabinet can be
adjusted within the range 34-50°F (1-10°C).
2. To lower the temperature in the cabinet, turn the
TEMP-ADJ knob from left to right (clockwise) by
the indicating black dot on the knob. A setting
close to 7 is the coldest, and a setting close to 1
is the warmest.
3. When using the appliance for the first time, turn
the knob to Coldest or 7 to cool down the cabinet
quickly.
4. The LED light inside is automatically controlled.
When you open the door, the light will turn on immediately and when you close the door, the light
will turn off automatically.
NOTES:
•
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
•
When you use the unit for the first time or restart the unit after it has been shut off for a long time,
there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
Door Lock
Your unit is provided with a lock and key combination. The keys are located inside the plastic bag
that contains the User Manual. Insert the key into the lock and turn it counterclockwise to unlock the
door. To lock the door, do the reverse operation, making sure the metal pin is engaged completely.
Remove the key and put it in a secure place for safekeeping.
Defrosting
This appliance requires no manual defrosting. During the operation of the compressor, ice will build
up on the evaporator plate which is at the back of inner cabinet. During the compressor's off-cycle,
the ice will melt, drip down, and collect in a tray above the compressor, where the compressor's heat
evaporates the water. If you notice excessive ice build-up on the evaporator, try setting the
temperature slightly higher. Also, be sure that the door gasket is sealing well.
Shelves
The unit has three removable glass shelves. To take out a shelf, first remove its contents, then raise
the back of the shelf slightly and pull the shelf out.
9
Advertisement
Table of Contents
