Advertisement
=
Pah [=F
EREEE
@ [AC24V~] Power input terminal
Connect the 24V AC power supply.
@ [VIDEO IRIS] Video iris terminal
Connected to an auto-iris lens containing an EE amplifier.
@ RS-232C Interface Connector
This connector is used for service.
@ [POWER] Power lamp
Lights when the power is on.
@® [VIDEO OUT] Video signal output connector
Outputs the video signal from the camera.
Connect to a video monitor, etc. (75Q)
© [WHT. BAL] White balance select switch
This is used for changing the setting of the white balance.
MANU: Manual adjustment is possible.
AUTO:
Accepts different types of lighting (2,850K —
7,000k) using an automatic tracking system.
@ [AGC] Automatic Gain Control Switch
This automatically increases the camera's sensitivity when
the level of ambient light drops.
ON: AGC is activated.
OFF: AGC is not activated.
@ [VIDEO IRIS] Video iris terminal
Connected to an audio-iris lens containing an EE amplifier.
@ RS-232C Interface Connector
This connector is used for service.
@ [POWER] Power lamp
Lights when the power is on.
@® [VIDEO OUT] Video signal output connector
Outputs the video signal from the camera.
Connect to a video monitor, etc. (75Q)
@ [WHT. BAL] White balance select switch
This is used for changing the setting of the white balance
MANU: Manual adjustment is possible.
AUTO:
Accepts different types of lighting (2,850K —
7,000K) using an automatic tracking system.
@ [BLC] Backlight compensation switch
This switch improves an image that is darkened because
of backlighting.
Set this switch to ON for backlight subjects.
@ [AES] Automatic Electronic Shutter switch
If this switch is set to "ON" when the manual iris lens is used, the
shutter speed varies according to the brightness of the object,
and the brightness of the image is automatically adjusted.
if the aperture is fixed or if an EE lens is used, set this switch to
OFF.
NOTE
e Hunting may occur at a certain object brightness due to the
mechanism of the AES circuit, but this is not a failure.
@ Synchronization select switch
INT: Set the switch to this position to use the internal sync
signal (SYNC or VS).
The camera operates in synchronization with the
internal sync signal.
LL: Set the switch to this position to use the frequency of the
24 AC power supply for synchronization (in 60-Hz power
regions only).
@ [PHASE] Line lock synchronization phase adjustment
Used to adjust the phase when the synchronization select
switch @ is set to "LL".
Adjust this volume so that the vertical phase of the camera
matches the vertical phase of another camera (or system)
with a multi-channel! oscilloscope.
(If the phases do not
match using this method, reverse the polarities of the
24V AC power to the camera, then adjust again.)
@ White balance adjustment controls
When the white balance select switch
@ is set to "MANU"
the white balance can be adjusted manually.
Turn to the "B" side to decrease the amount of red.
Turn to the "R" side to decrease the amount of blue.
© [AGC] Automatic Gain Control Switch
This automatically increases the camera's sensitivity when
the level of ambient light drops.
ON: AGC is activated.
OFF: AGC is not activated.
@ [BLC}] Backlight compensation switch
This switch improves an image that is darkened because
of backlighting.
Set this switch to ON for backlight subjects.
@ [AES] Automatic Electronic Shutter switch
If this switch is set to "ON" when the manual iris lens is used,
the shutter speed varies according to the brightness of the
object, and the brightness of the image is automatically adjust-
ed.
if the aperture is fixed or if an EE lens is used, set this switch to
OFF.
Advertisement
