Table of Contents
Advertisement
SECTION 3
OPERATION
IV. NORMAL OPERATION - STEP-BY-STEP
A.Daily Startup Procedure
1.
Check that the circuit breaker/fused disconnect is in the
on position.
2.
Turn the "BLOWER"
switch to the
(
)
"ON" ("I") position.
3.
Turn the "CONVEYOR"
(
) switch to the "ON"
("I") position.
4.
If necessary, adjust the
conveyor speed setting
by pressing the
or
pushbuttons on the
conveyor speed controller
to change the displayed
bake time.
5.
Adjust the temperature
controller to a desired
set temperature, if neces-
sary.
•
Press the Set Point
and Unlock keys
at the same time.
Wait for the "SET
PT" light to turn on.
•
Press the Up Arrow
and Down Arrow
Keys as necessary
to adjust the set-
point.
6.
Turn the "HEAT" (
switch to the "ON" ("I")
position, and wait for the
"HEAT ON" light to turn
on.
wait
+
for
or
)
wait
for
7.
Wait for the oven to heat to the setpoint temperature.
Higher setpoint temperatures will require a longer wait.
The oven can reach a temperature of 500°F (232°C) in
approximately 15 minutes.
8.
(Optional) Press the
Temperature ( ) key
to show the Actual
T e m p e r a t u r e i n t h e
display, and wait for the
"ACTUAL TEMP" light
to turn on. This allows
you to monitor the oven
temperature as it rises to
the setpoint.
9.
Allow the oven to preheat for 10 minutes after it has reached
the set point temperature.
B. DAILY SHUTDOWN PROCEDURE
1.
Turn the "HEAT" (
or
"BLOWER" (
to the "OFF" ("O") position.
Note that the blowers will
remain in operation until
the oven has cooled to
below 200°F (93°C).
2.
Make certain that there
are no products left
on the conveyor inside
the oven.
Turn the
"CONVEYOR" (
switch to the "OFF" ("O")
position.
3.
After the oven has cooled and the blowers have turned to
the "OFF" or "O" position, switch the circuit breaker/fuse
disconnect to the "OFF" or "O" position.
In case of power failure, turn all switches to the "OFF"
("O") position and remove the product. After the power
has been restored, perform the normal startup pro-
cedure. IF THE OVEN WAS SWITCHED OFF FOR
LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE
MINUTES BEFORE RESTARTING THE OVEN.
20
) and
) switches
)
CAUTION
wait
for
Advertisement
Table of Contents
Troubleshooting
