Table of Contents
Advertisement
4.
Lay Motor Unit on its side on bench with the collet pointing
AWAY from you.
5.
Place one wrench on flats on Chuck with the opposite end of the
wrench resting on the bench to your left, Fig. 3.
6.
Place
other
wrench
on
Collet
and
tighten
COUNTERCLOCKWISE as shown in Fig. 3. TIGHTEN FIRMLY.
7.
To remove the bit, reverse the foregoing procedure.
AVOID POSSIBLE DAMAGE TO COLLET. NEVER TIGHTEN
COLLET WITHOUT BIT.
ASSEMBLING THE MOTOR IN THE ROUTER BASE
EQUIPPED WITH TWO KNOBS
1.
DISCONNECT
motor from power source.
2.
Loosen the Clamp
Screw (A) Fig.
4
to
allow the Power Unit to be
set in the Base Unit.
3.
Insert Motor
Unit into base aligning lower pin
(B) with groove
in base.
4.
Rotate Motor
Unit CLOCKWISE into base until upper guide
pins
are rigidly
set in
the
groove of the base.
5.
Tighten
Clamp Screw firmly.
Fig. 4
ASSEMBLING THE MOTOR IN THE ROUTER BASE
EQUIPPED WITH SWITCH-IN-HANDLE
1.
DISCONNECT Power Cords.
2.
Loosen Clamp Screw (A) Fig. 5 to allow the Power Unit to be set
in the base.
7
Advertisement
Table of Contents
