Air Baffle; Baffle - Lenovo ThinkSystem SR665 V3 User Manual

1. Install the system fan cage. See
2. Complete the parts replacement. See
Remove a RAID flash power module from the air baffle
Follow instructions in this section to remove a RAID flash power module (also called supercap) from the air

baffle.

About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Disconnect the cable of the RAID flash power module.
Step 2. Remove the RAID flash power module from the air baffle.
Figure 155. Removing the RAID flash power module from the air baffle
ThinkSystem SR665 V3 User Guide
194
"Install the system fan cage" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
270.
279.
"Remove the server from rack" on page
277.
to ensure that you
63.