Install The Front Pcie Adapter And Riser; Card - Lenovo ThinkSystem SR665 V3 User Manual

Figure 64. Removing the riser card from the riser 5 cage
a. Remove the screws that secure the riser card.
b. Rotate the riser card from the top to disengage it from the screw holes on the riser cage.
c. Lift the riser card out of the riser cage.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front PCIe adapter and riser card
Follow instructions in this section to install the front PCIe adapter and riser 5 card.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• For PCIe adapter installation rules, see
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr665v3/downloads/driver-list/
see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 467
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
and "Safety inspection checklist" on page 48
62.
"PCIe slots and PCIe adapters" on page
for more information on firmware updating tools.
54.
.
Chapter 5 Hardware replacement procedures
to ensure that you
to
107