Summary of Contents for Lenovo ThinkSystem DM Series
Lenovo ThinkSystem DM Series NVMe 2U24 SIR rail kit installation instructions This guide describes how to use SM17A56607 to install a DM NVMe 2U 24-drive chassis in a four-post rack for ship-in-rack enablement purpose. Before you begin Before you begin the installation, check the parts contained in SM17A56607.
Step 2. Place the back of the chassis on the rails, and then carefully slide the chassis all the way onto the rails. Figure 2. Installing the chassis on the rails Step 3. Take out the parts from Rail Hardware Kit SM17A56613, align a 2 mm-thick washer (340-12808) with the upper hole on the left or right chassis ear, and then fasten the ear with a flange screw (340- 12807) to fix the chassis to the rails.
Step 4. Press down the tabs and grasp the handles on both sides at the same time to remove the lower module on the rear side of the DM NVMe 2U 24-drive chassis as shown. Then, keep it in a safe place.
Step 6. Re-install the lower module on the rear side of the DM NVMe 2U 24-drive chassis as shown. Figure 6. Installing the lower module back on the rear side The installation procedure is completed.