Table of Contents
Advertisement
MACHINE SETTINGS
(Fig. B)
Through a programming menu it is possible
to set the water hardness and the acoustic
signals.
Activation / deactivation of acoustic
signals.
The acoustic signals can be disabled /
enabled by keeping the keys (21) and (24)
pressed for three seconds; the key (21) flashes
three times indicating the memorization of the
setting.
Setting the water hardness.
The machine is factory set to "Hard Water
Level". The machine can also be set according
to the actual water hardness in the various
regions for less frequent descaling.
If you don't know the water hardness, use
the supplied test strip (19) and follow the
instructions below.
• Remove the supplied reactive strip from its
packaging.
• Fully submerge the strip in a glass of water
for about one second.
• Remove the strip from the water and slightly
shake it. Read the results after about one
minute.
If 5 blue stripes appear on the strip, select
"Soft water" settings.
If 1 or 2 pink stripes appear on the strip, select
"average water" settings.
If 3, 4 or 5 pink stripes appear on the strip,
select "hard water" settings.
• To open the water hardness settings,
simultaneously press and hold down keys (20)
and (24) for at least 3 seconds, LEDs (25),
(26), (27)will flash simultaneously.
EN - 8
Use
• Choose the water hardness, referring to the
following table, pressing the key (20), the
LED relating to the selected hardness lights
up steadily, the others go off.
Led
25
26
27
• To memorize the selected hardness, press
keys (20) and (24) simultaneously for at least
3 seconds or do not press any key for 15
seconds.
To prolong the machine operation
and preserve the aroma and taste of
the coffee, it is recommended to use
the Smeg Softener Filter (optional,
not supplied). For installation and
operation, follow the instructions
that accompany the accessory.
Once
water hardness level to 'Soft'
following the
the previous paragraph.
Hardness
Soft
Medium
Hard
installed,
instructions
set
the
in
Advertisement
Table of Contents
