Advertisement
RX-FT570
MFM ALIGNMENT
ssh tolaebea ay
et
e a e ELECTRONIC
ADJUSTMENT
SWEEP GENERATOR
BAND
SETTING
VOLTMETERor _| (ShowninFig.1)
REMARKS
CONNECTIONS
FREQUENCY
|
OSCILLOSCOPE)
FM-IF ALIGNMENT
High side thru.
0.001mF to test point
Point of non-
Connect vert. amp.
FM-RF ALIGNMENT
Headphone Jack (32)
(15)|
FM
(E)(EB)..86.2MHZ}
Variablecapacitor
Fabicste ie plug as shown
L2 (FW OSC
[*3] Adjust for maximum
in
Fig.2 and
then connect
:
(EG)....87.35MHz! fully closed.
ine os aresarnc Gnd
| Coil)
output.
Connect to test point
the measuring instrument.
ids through FM (75W
(16)|
EM
unbalanced) dummy
Variable capacitor
CT1-1(FW OSC
to test point BEZY.
Adjust for maximum
output.
Repeat steps (15)~(17).
CT1-2 (FM ANT
Trimmer)
106MHz
Tune to signal
[*3] three output responses will be present; proper tuning is the center frequency.
Mi TAPE SPEED ALIGNMENT
EQUIPMENT CONNECTION
|
TEST TAPE
ELECTRONIC COUNTER
ADJUSTMENT
REMARKS
Headphone Jack (32)
Normal Speed Adjustment
Tae)
ee poe,
VR401
1. Insert a test tape (QZZCWAT) in Deck 1 and play it back.
ri sais Misa _ bd —
2. Adjust VR401 until the measured value becomes 3000
+ 30Hz.
3. Check Deck 2 in the same way to make sure it satisifies the specification.
Deck 2...+50Hz of the speed of Deck 1.
If it doesn't repeat steps 1 and 2 above.
Note : This set uses one driver motor,so be sure to perform the adjustment in Deck 1.
4. Insert the playback tape inDeck 1 and the editing tape in Deck 2.
5. Set the Editing Mode Selector to the "High" position.
6. Press the Deck 2 Pause Button, then press the the Record Button.
7. Press the Deck 1 Playback Button.
Editing is started by means of Synchro-Start function.
8. Check be sure that the measured speed is at least 1.7 times faster than normal speed.
Advertisement
