Jeep RENEGADE 2023 Quick Manual page 36

Turn off the engine, turn on the hazard
warning lights, stop the car safely, activate
the electric parking brake and engage
1 st gear if driving uphill or reverse gear
if driving downhill, steer the wheels
completely. When parked on a steep
slope, place a chock, or a rock, behind the
wheels and restore the pressure using the
black compressor tube until reaching the
prescribed pressure.
If also in this case the pressure is lower
than 2.0 bar / 29 psi 10 minutes after
turning on, do not resume driving and
contact a Jeep Dealership.
After driving for approx. 8 km / 5 miles
fig. 51, park the car in a safe and
convenient area, turn off the engine, turn
on the hazard warning lights and activate
the electric parking brake; engage the 1
gear if driving uphill or the reverse gear if
driving downhill, with the wheels completely
turned. When parked on a steep slope,
place chocks or a rock behind the wheels.
Take the compressor and restore the
pressure using the black inflation tube.
If the pressure shown is higher than
2.0 bar/ 29 psi, restore the pressure and
drive safely to a Jeep Dealership as soon as
possible. If, however, the pressure is lower
than 2.0 bar/ 29 psi, do not resume driving
and contact a Jeep Dealership.
Pressure relief valve
If the tyre pressure is higher than expected,
it is possible to lower it, after turning off the
compressor, by pressing the button fig. 52
located near the connector fixing the black
tube.
34
52
ATTENTION
49) ATTENTION: Do not exceed 80 km/h.
Avoid sudden acceleration or braking.
The TireKit provides a temporary repair,
st
therefore the tyre must be examined and
repaired by a specialist as soon as possible.
Before using the TireKit, ensure that the
tyre is not damaged excessively and that
the rim is in good condition, otherwise do
not use it and call roadside assistance. Do
not remove foreign bodies from the tyre.
50) Punctures on the sides of the tyre may
not be repaired. Do not use the TireKit if the
tyre was damaged as a result of being used
when underinflated.
51) Wear the protective gloves provided
with the TireKit.
52) Apply the adhesive label where it can
be easily seen by the driver as a reminder
that the tyre has been treated with the
TireKit. Drive carefully, particularly on
bends.
53) Repairs are not possible in the case
of damage to the wheel rim (bad groove
distortion causing air loss). Do not remove
foreign bodies (screws or nails) from the
tyre.
54) As required by current regulations,
the information on chemical substances
for the protection of human health and the
environment and on the safe use of the
sealing fluid are on the packaging label.
J0A5094 Compliance with the indications on the
label is an essential condition to ensure
the safety and the effectiveness of the
product. Remember to carefully read the
label before use; the user of the product
is responsible for any damages caused
by improper use. The sealing fluid has an
expiry date. Replace the bottle if the sealant
has expired.
55) If the pressure falls below 1.8 bar, do
not drive any further: the TireKit cannot
guarantee proper seal because the tyre is
too damaged. Contact a Jeep Dealership.
56) The TireKit is not suitable for definitive
repairs, so the repaired tyres may only be
used temporarily. The TireKit provides a
temporary repair, therefore the tyre must be
examined and repaired by a specialist as
soon as possible.
57) The surface of the flexible pipe can be
hot.