Table of Contents
Advertisement
VERSIONS WITH MECHANICAL
KEY
15
ATTENTION
2) If the ignition device has been
tampered with (e.g. an attempted theft),
have it checked over by a Jeep Dealership
before driving again.
3) Always take the key with you when
you leave your car to prevent someone
from accidentally operating the controls.
Remember to engage the electric parking
brake. Never leave children unattended
in the car.
4) Before leaving the car, ALWAYS engage
the parking brake. On versions with
automatic transmission / dual-clutch
automatic transmission / electrical dual
clutch automatic transmission, move
the gear lever to P (Park) and press the
ignition device to set it to STOP. When
leaving the car, always lock all the doors
by pressing the button on the handle.
5) For versions equipped with the Keyless
Enter-N-Go system, do not leave the
electronic key inside or near the car or
in a place accessible to children. Do not
leave the car with the ignition device in
J0A0021C
MAR position. A child could activate the
electric window winders, other controls or
even start the car.
OPERATING MODES
RENEGADE PLUG–IN
HYBRID VERSION
While driving, by pressing the buttons
located on the central tunnel, fig. 16 you
can select three different operating modes:
HYBRID
ELECTRIC
E–SAVE
The engine will start in "ELECTRIC"
mode if this mode was selected the last
time the engine was switched off, and
if the conditions are right to enable it
(temperature, slope, state of charge of the
high-voltage battery), otherwise it will start
in "HYBRID" mode.
6) 7)
16
NOTE Once a month, and in particular in
cold environments, it is recommended to
use the heat engine (by activating "4WD"
mode or the transmission in manual
sequential mode) for up to 60 consecutive
minutes.
"HYBRID" MODE
Activating the "HYBRID" operating mode
optimizes fuel consumption.
J0A6036E
13
Advertisement
Table of Contents
