Table of Contents
Advertisement
25) Should one or more wheels be fitted
without sensors (e.g. if the spare wheel
is fitted), the system will no longer be
available for the replaced wheel and a
warning message will be shown on the
display, until the wheels with sensors are
fitted again.
26) The TPMS cannot indicate sudden
tyre pressure drops (e.g. if a tyre bursts).
In this case, stop the car, braking with
caution and avoiding abrupt steering.
27) Changes in external temperature may
cause tyre pressures to vary. The system
may temporarily indicate insufficient
pressure. In this case, check the tyre
pressure when cold and, if necessary,
restore the inflation values.
28) When a tyre is removed, it is advisable
to replace the rubber valve seal as well:
contact a Jeep Dealership. The fitting/
removal of the tyres and/or rims require
special care. To avoid damaging or fitting
the sensors incorrectly, tyre and/or rim
fitting/removal operations should only be
carried out by specialised technicians.
Contact a Jeep Dealership.
22
WARNING
1) The tyre quick repair kit (TireKit),
provided with the car, is compatible
with the TPMS sensors. Using sealants
different from that in the original kit may
compromise its operation. If sealants not
equivalent with the original one are used,
it is recommended to have the TPMS
sensor operation checked by a qualified
repair centre.
CHARGING (RENEGADE
PLUG–IN HYBRID VERSION)
29) 30)
2)
Before charging the high voltage battery, it
is recommended to turn the ignition device
to STOP in order to obtain a charge until full
in the shortest period possible.
WARNING The brake caliper lock is
activated during the charging procedure:
unlocking will be carried out automatically
at the end of the charging procedure.
CHARGING PORT ON THE CAR
26
To access the charging port, open the
charging flap (A) fig. 26 located on the left
side by pressing on the area indicated by
the arrow.
J0A6030E
Advertisement
Table of Contents
